Japanese Teapot Set can be seen everywhere in life, but they are still very particular about installation. The components of the processed Japanese teapot set will not have defects such as cracks, hidden residues, stains, red and white lines, stone flaws, stone iron, etc. It can be hammered carefully with a hammer. If there is a sound of Dangdang, it means that there are no cracks and hidden parts of the Japanese Teapot Set.
The direction of the
Teapot And Kettle should meet the force requirements of the components, the earthen stone should be horizontal, and the columns and corner columns should be vertical. The variety, quality, processing standard, specification, size, label, and color of Japanese
teapot set components should meet the design requirements, and have a factory certificate and test report. Check the number marks on the components. If the numbers are incomplete and not obvious, they should be supplemented to avoid wrong installation.
Check whether the tenon length of the Japanese teapot set components meets the design requirements. If there is no specific requirement in the design, the tenon length is generally not less than 60mm. Check whether the stair sections, corners, arcs or other special-shaped components are lofted and blanked according to the requirements of the drawings, and whether the pattern processing and angle control of the special-shaped components are accurate.
Before the Japanese teapot set is installed, the technical disclosure work should be done well. According to the design requirements, combined with the site conditions to develop a construction plan. Check wires to check whether the surface elevation of the foundation cushion meets the design requirements. If unevenness is found, it should be filled with fine stone concrete. Before the Japanese teapot set is installed, it is necessary to draw the arrangement diagram of the Japanese teapot set's ground stones, slab stones, pillars and other components according to the design drawings, and release the centerline and sideline of the stone components at the construction site.
Before the Japanese teapot set is installed, the dirt, scale and other impurities on the surface of the stone components should be removed, and if necessary, wash with water. The strength grade of selected stone components should not be lower than MU20. The mortar for basement grout shall be cement mortar with a strength grade not lower than M10.
